Source build-to-print RF interconnects for antennas, telematics modules, and vehicle camera systems. Send the mating part numbers for both ends and your routing constraints. OUKETECH will review the configuration before quoting samples or production.
End A
Connector series, coding and mating part number
Cable
Type, finished length and routing clearance
End B
Connector series, orientation and mating part number
Start with the ports on the equipment drawing. Confirm both mating interfaces before finalizing the cable and length.
For a link between two FAKRA ports, identify the coding and contact configuration at each end. A replacement or FAKRA extension cable should be checked against both mating ports and the available routing space.
For a FAKRA-equipped device that mates to SMA equipment, specify the SMA interface and part number, cable exit and panel clearance. Review more SMA cable assembly configurations.
Provide the connector series and manufacturer part number for both ends, including coding and plug or jack. For a right angle FAKRA cable, show the direction of the cable exit and the clearance needed to release the connector.
For a FAKRA coax cable, specify the cable part number, impedance, finished length and tolerance. If your drawing calls for an RG174 FAKRA cable or an RG316 FAKRA cable, confirm that the specified connector and tooling match that cable.
Identify mounting and strain relief, jacket exposure, abrasion points and any sealing requirements at the mated interface. Review connector overmolding options when the drawing calls for molded protection.
An automotive FAKRA cable assembly should be specified around the mating equipment, installation location and signal requirements.
Provide the antenna and receiver ports, frequency range, routing length and loss budget so the cable selection can be reviewed against the system.
List the ports at the module and antenna, the routing and the space for the connector backshell. If the RF lead is part of a larger loom, include the breakout location in the vehicle wiring harness.
Send both device part numbers and the required interface series, including any Mini FAKRA designation. Include routing and bend clearance near the camera mount.
Send your drawing, BOM revision, approved part numbers and quantities for sample and repeat builds. Flag parts that require approval before substitution.
Check both ends against the mating equipment and confirm the finished length, cable exit and installation fit. Record any approved changes on the released drawing.
Identify the required visual and dimensional checks, electrical checks and sample records. Where insertion loss or return loss is required, specify the frequency range, limits and reporting format so the test scope can be reviewed before quoting.
Yes. Start with photos of both ends, equipment model numbers, a length measurement and the expected quantity. Include any readable part numbers. Confirm the mating interfaces and drawing before releasing the build.
Include the requested series, exact part numbers and the mating device documentation. Confirm coding and fit during the review, especially when a FAKRA Z cable is proposed for an existing installation.
Send the mating part numbers and cable requirements. OUKETECH’s RF and coaxial cable assembly capabilities cover a broader range of interfaces for mixed-connector builds.
Share your drawing or BOM, both mating part numbers, cable type and finished length, sample and production quantities, and any inspection or RF test requirements. If the drawing is still in progress, tell us which interfaces and routing dimensions are already fixed.
Start with the information you have. Include your drawing revision so the quote and sample can be tied to the same build.