BUILD-TO-PRINT FOR LIGHTING OEMs
OUKETECH builds custom wiring harnesses for LED fixture manufacturers, from short driver-to-module leads to branched harnesses that distribute power and control inside a luminaire. We work from your drawing, BOM or reference sample and support prototype builds through repeat production.
01 Driver output
Output mode, polarity and supply limits
02 Harness routing
Trunk, breakouts and strain relief
03 LED module
Mating header, latch access and pin map
HARNESS CONFIGURATIONS
Define the driver output pins, LED board header, polarity and lead length. For a replaceable LED module, specify how the connector should be accessed during service.
For linear fixtures, displays and signage, mark each branch destination and breakout point. Identify the shared feed and return conductors so they can be sized for the combined load.
For landscape, architectural and equipment lighting, show where the harness crosses the enclosure and identify any exposed mating interfaces. Specify cable exit, strain relief and the required sealing condition.
DRAWING AND BOM INPUTS
Provide the driver and module models, output type, maximum branch current, supply and return pins, and any dimming or control pin assignments. Identify each connector view on the pin map.
Show connector clocking, latch access, branch lengths and tolerances, grommet positions, mounting clips and the space available around bends. Mark hot surfaces and sharp edges on the routing sketch.
List housing, terminal and mating part numbers, wire construction, insulation requirements, labels and any approved alternates. Flag customer-controlled parts and long-lead items before sampling.
DESIGN REVIEW
For a constant-voltage circuit, define the minimum voltage required at the farthest module under load. Use the full supply-and-return path and account for shared conductors, terminals and splices when setting the drop budget. For a constant-current circuit, confirm the driver’s output voltage range covers the LED string’s forward voltage plus wiring losses under the specified conditions.
Keep the driver input, LED output and dimming circuits identifiable on the schematic and harness. Review routing, separation and any shielding or grounding requirements against the driver instructions and fixture design. For an outdoor build, define the connector’s mating state and assess the enclosure entry and cable exit as part of the sealing plan.
SAMPLING AND PRODUCTION
Send the latest drawing revision and an expected order quantity so we can review component availability, tooling and the sample plan before quoting.
Resolve connector orientation, approved parts and assembly tolerances. Record any proposed substitution for approval before it enters the BOM.
Agree on continuity, polarity, pin mapping and dimensional checks. If you need powered fixture checks, pull-force data or environmental validation, specify the fixture, sample count, method and acceptance limits for review.
Approve the sample against the installed fit, pin map and agreed records. Use the released revision and approved BOM for subsequent orders. Confirm documentation, marking and packaging requirements before release.
BUYER QUESTIONS
Yes, send photographs of both ends, the mating part numbers if available, a routing sketch and the approximate quantities. A reference sample helps establish fit. Before release, confirm the pin map and dimensions against a controlled drawing.
Send the replacement housing, terminal and mating part numbers for review. Verify the latch, keying, wire range and fit, then update the BOM and agree on any repeat testing before using the replacement in production.
Yes. Share the exposure, target ingress requirement and installed configuration. Include the housing entry, any open connector during service and the specified test setup so we can review the assembly against the actual use conditions.
RELATED MANUFACTURING CAPABILITIES
See our custom wiring harness capabilities for multi-branch layouts, routing and assembly documentation.
Review overmolded cable assemblies when the design calls for an integrated cable exit or strain relief.
Explore sealed cable assembly options for interfaces that are exposed to water or dust in service.
OEM QUOTE REQUEST
Upload your drawing and BOM if available. Include the fixture application, driver and module part numbers, pinout, sample and production quantities, delivery destination and any acceptance tests.
Working from a prototype? Tell us which connections and dimensions are already fixed and which are open for review.